Protank Dual Coil rebuild

[VaperGlock]

I just rebuilt a Kanger dual coil head and it came up to 1ohm. I was hoping for 1.5 to 2. I understand if each coil is say 2ohms then your overall resistance will be 1. My main question is what gauge wire and # of wraps would it take to get to my target resistance? I used 30ga with 9 wraps per coil on my 1st attempt. There would've been a little room for more wraps but it would've been a tight fit. I have access to 28, 30and 32ga kanthal. Thanks for the assistance!!!

 

[State O' Flux]

Here's a link to ancient puffer's coil spreadsheet.

 

[VaperGlock]

Here's a link to ancient puffer's coil spreadsheet.

That looks like it'll be helpful once I figure it out lol Thanks!!!

 

[VaperGlock]

Here's a link to ancient puffer's coil spreadsheet.

The chart worked splendidly. Second coil came in at 1.8Ohms. Perfect and thanks again!!!