protank mini 2 and vamo v5

[Drone82]

Hi all. I've noticed that, when using my mini on my vamo that it wobbles. I only tighten until I feel resistance, but it leaves about 2-3 mm gap between the bottom of the mini's ego connector and the flat top of the vamo. The tank will occasionally get bumped and start to work its way loose until it doesn't fire. I just dont want the treads to get stripped or push th center pin in. Would the "o-ring on the top of the vamo trick" do the job? Or would that just place undue upward stress on the threads?

Also when using a 510 tank or Atty, I know that there will be the gap between the tank and beauty ring, but is it safe to tighten it down to the top of the post?

 

[salemgold]

You do not want to over tighten it. I bet that a 510 to 510 adapter will do the trick for you. It has for me in the past in similar situations.

Good luck!

This is a good one because it is sealed. It will prevent juice from getting into your Vamo if there are any leaks. Adapters are also a good idea because they save wear and tear on the mod threads.

V2 510 Shorty Extension Sealed

 

[Drone82]

Well I found an easy solution for the ego thread issue. I'm sure you can find a dozen other places where this idea is shared though lol. I cut an old credit card down and drilled a hole in the center. I pushed it down flat onto the top of the vamo around the post. Protank mini sits nice and tight now no wobble. Much more secure feeling.