Provape ProVari Tank Ring in Stock Again
- Thread starter Moonswanni
- Start date
- th_trl_thread_readers 0
- Status
If someone (me) doesn't care the way it looks, are there any other advantages to buying one?
I just ordered two this morning. I've had a couple from other manufacturers in the past, but I keep losing them. 
Tina, they are basically beauty rings. If you use something like the Protank, the Provape-made beauty rings do have airflow slits in them which should aid in airflow.
Tina, they are basically beauty rings. If you use something like the Protank, the Provape-made beauty rings do have airflow slits in them which should aid in airflow.
Last edited:
Yes it will, and because your username is so awesome, you get this cool signature too. Send me a PM if you need help adding it to your signature line.
yes it will, and because your username is so awesome, you get this cool signature too. Send me a pm if you need help adding it to your signature line.
thank you for the signature
I just got mine today. Its the same finish as the tapered section. Now I need a polished Kayfun.
Last edited:
I got one in a couple of days ago. I've only used the ProTanks and Davides so far. Sometimes the tanks don't sit flat on top of the ProVari and leaves a very small space between the two. I love how this ring solves the problem and danged if it don't look good too! It's a bit wider than the bottom of the tanks, but not by much; and because of the spoked grooves on the top of the ring, it adds a bit of a decorative touch. I'm kind of disappointed when I don't need to use it! 
I prefer it to the tapered pro ring that was provided by SvoeMesto. I got one from the classies when I bought my Blue and it works fine, but I prefer the looks of the one from ProVape.
Thankfully I have 3.1ES clones with adjustable 510 heads on them so I can adjust it to make contact with the ProVari.
Got one when I got my mini. Got a small issue with my KFL+ clone.
See the gap in the pic below. Fit is loose. Any suggestions?
See the gap in the pic below. Fit is loose. Any suggestions?
I had that problem. I didn't have the bottom section to the Kayfun screwed tight enough; then I screwed it on too tight and had an issue getting it off. LOL Another time I had the "connector pin" sticking out too much.
That's good to know because I'm thinking about getting one of the originals Kayfun and I like accessories! My Kayfun hasn't been off my Provari since I got it ... OK ... maybe once.
Got one when I got my mini. Got a small issue with my KFL+ clone.
See the gap in the pic below. Fit is loose. Any suggestions?
I cut a little ring out of plastic that can sit on top and fill the gap. I'm sure there is a prettier/better way but I haven't gotten around to finishing this project...
http://www.e-cigarette-forum.com/forum/provape/547313-have-any-ideas-cure-3.html#post12729496
- Status
