All, I built my puck mod today and used everything he recommended, but didn't specify a resistor for the led.
I put a blue led and 470ohm 1/2 watt version. When I hit the fire button the light goes out and minimal vape. Without atty light is nice blue light. Was getting 4.5v ish when I hooked volt meter to adapter without atty.
I did check the atty which is a 3.0 ohm short bridge dripper atty.
i am am also using a 901-510 converter and reads atty fine on ohm meter with or without adapter.
do I have the wrong ohm coil? Which is best? Also right resistor?
Thanks all, I wanted to try an easy version before going whole hog into a full size one.
I put a blue led and 470ohm 1/2 watt version. When I hit the fire button the light goes out and minimal vape. Without atty light is nice blue light. Was getting 4.5v ish when I hooked volt meter to adapter without atty.
I did check the atty which is a 3.0 ohm short bridge dripper atty.
i am am also using a 901-510 converter and reads atty fine on ohm meter with or without adapter.
do I have the wrong ohm coil? Which is best? Also right resistor?
Thanks all, I wanted to try an easy version before going whole hog into a full size one.