Question about mech mods

[mrdfield]

Hello I am interested in trying a mech mod I own all VV/VW apvs a VTR and a MVP 2 and a couple of itaste vv's
I am looking at the mech mods cause with summer coming I see that a lot of them are a lot shorter and seem more pocket friendly the itaste vv is small in width but kinda tall when carrying in my pocket anyway Do I have to use rebuildble coils can't I just use what I own now which is a couple of ibtankeds and iclear 30s just looking for something small enough to throw into pocket for the beach and other summer stuff I usually vape at 9 Watts is it going to be enough of a hit with the mech mods
Thanks for your input


Sent from my iPhone using Tapatalk

 

[iitzBeast]

Idk, if you want something small go with a telescopic mod (kamry 100 or 101) should do good for you, pop in an 18350 and you got a 2 inch base. Then pop on any clearomizer or atty you got and boom, off to the beach

 

[Dogeggs]

You can put anything with a 510 connection on a mech, the only issue you will have is the unregulated power, ie your voltage/watts will decrease as you use it, unless you use a kick, but using a kick will make the mod longer.

 

[Baditude]

And, depending upon the ohm or resistance coils you were using on your MVP & VTR attachments, you may need to use lower resistance coils with the mech. Not sub-ohm, but 1.5 - 2.0 ohm factory-built coils.

 

[30+Years]

Even in 18350 mode I don't see a mech mod much more conventient to carry than your MVP. And the battery life would stink in comparison.