Question about the new kanger SUB OHM coils.

[CloudPusher]

I just got a 5 pack of the new .8ohm kanger coils and popped one in(I have the kanger protank 3 with the adjustable airflow valve accessory wide open) and put it on my mech with a Efest IMR 35A battery. Basically i am not impressed. I can get the same vape with the 1.8 ohm coils on my APV. Can i put this setup on my APV and turn up the voltage on it? I also have a kick for my mech. Can i use that? And if so, what's the point of using this entry lvl pre-made sub ohm build if it does not give the performance one would expect out of this fancy smancy sub ohm thingamagig?

 

[CloudPusher]

As a matter of fact, I have a 1.8ohm micro coil in my mini RDA with a 1/16in hole that vapes waaaay better than this. pfffft

 

[SleeZy]

I think you will be better of building a subohm coil yourself in the protank. (not recommended though.)
My 0.9-1 ohm build just burned the grommet realy quickly.

 

[Unforeseen]

Moved to Assorted APV Discussions - Clearomizers

 

[eazye99]

I'm running a 1ohm on my protank clone from fasttech. Mine hast melted the insolator. I had a .8 in it before. It didn't burn or melt as well. I'm using it in a nemesis. As long as u have good wicking and airflow. U should be fine. I wouldn't try chain Vaping it though. That could lead to melting. I'm getting the best gap for me at this setting. I believe its 28g wire.