- Status
Don't know about the MT'3's but the Evod heads will. Only difference it the Evod heads have a tighter draw.
also do you need to take out the two wicks in the coil? i've seen it somewhere they suggest doing that for better vapor and taset
I've been using my T3S heads in my mini protank just fine. I don't know if the mini uses the same heads as the PT2 though. I haven't needed to remove the top wicks, I guess that would depend on how thick your juice is 
Hi!
I've used the t3s in evods without a problem.
If you have some mt3s on hand, give it a try....
Good luck and happy vaping!
I've used the t3s in evods without a problem.
If you have some mt3s on hand, give it a try....
Good luck and happy vaping!
T3S/MT3S heads can be used in any Kanger BCC tank, PT/PT2/Mini PT/Mini PT2. With the T3S base, can be used in older T3 tanks. Protank and Evod heads, can not be used in a T3/T3S tank system. Only difference in the three types of heads, the T3S head in narrower by a couple micro-meters at the bottom flange of the head that seats flush on the base. So yes, it is compatable with the Protanks. Regarding the flavor wicks, if you getting dry burns, remove one wick, test it out, still getting dry burns, remove the next one, depending on the viscocity of your liquid (PG/VG ratio, higher VG will need flavor wicks removed).
And depending on juice viscosity and vaping style, removing the flavor wicks may result in leaks.
My preferred local shop is only stocking the T3s coils. I can see the rationale, as they will always have a coil that will work with any of the Kanger models they sell.
I actually prefer the T3s heads in my protanks. The narrower flange (according to my theory) lets a little more juice get under the wick tips so that they are being saturated from all sides- better wicking. I also have not experienced any leaks. I like this set up especially in the Protank 2
- Status
Similar threads
- Locked
