Questions about iclear 16 tank

[kristalk]

Hello,
This is my first post and I have some questions about tanks. I've owned 3 different tanks that have the coil in the bottom; mt3, t3s, and gs-h2. All of those tanks gave me the same issues, the ejuice keeps leaking out of the center of the coil and down into my battery. I was pretty much buying a new coil every week because of this. Each time I bought a new coil, the coil would be fine for the first few days with no leakage and then it'd leak. After my experiences with the bottom coil tanks, I went to this store that specializes in vaporizers/e-cigs and told the clerk about my tank issues. He suggested that I'm drawing too hard and I need a tank like the iclear 16 one. I took his advice and bought the tank he suggested for me, but lone behold this tank is giving me issues also. When I try to smoke on my Iclear, the pulls are very resistant. Every time I draw on this tank I have to suck so hard that my eyes start to bug out of my face. After doing some research about this tank, I'm finding that the dual 2.0 ohm coils are meant for a battery with variable wattage/voltage and the 1.5 ohm coil is best with the non variable batteries. He sold me the one with the 2.0 ohm coil. My battery is non-variable, its just a standard EVOD battery... So, my questions are: 1. Is the reason why the pulls are resistant is because my battery is non-variable? 2. Should I take out the 2.0 ohm coil and go buy a 1.5 ohm coil to replace it with? 4. is it true that my draws could be causing the bottom coil tanks to leak? 3. any other suggestions?

 

[Lucky1127]

All tanks leak some more than others have tons of tanks. Cheap tanks to very expensive tanks they leak with changes in temp o rings swelling you can most certainly use the 1.5 coil on that iclear and I would say stay with lower ohm coils using a set voltage device.

 

[milescadre]

sooo

1: The battery may be affecting your draw by blocking the airflow holes. HOWEVER ,the function of the battery should not affect the draw.
2: the difference between the 1.5 and 2 will be a warmer draw on the 1.5. the ammount of air you move through, however, shouldnt be affected.
3: yes, heavy stiff draws can cause these tanks to leak. slow soft draws should be used.
4: definitely check to make sure theres no resistrictions. if your coil is flooded, it will make for a tighter draw. also, try loosening your tank jsut a very tiny bit to see if it helps to loosen the draw.

 

[Bolivar]

What is your pg/vg ratio on your liquid? It may be too thick to draw through the tank you are using. The higher the vg, the thicker the juice .