Ratio for nonflavored E-Liquids needed

[roberted5]

I just like the taste of plan nicotene gum.I've tried all the flavors and the more flavor they add the worst it tastes.

I had the best luck not smoking before E-cigs using plain nicotene gum,I liked the taste and it gave the same effects but just took longer.

I looked through all the reciepies but couldn't find any non-flavored or with the taste of nicotene gum.

If anyone can suggest a starting ratio for the ingredients,that would be great.

So far I understand you use nicotene w/PK or glycerin base,distilled water,and more glycerin.

I have read a few that use a little Everclear or close to 100% ethanol to help the liquid dry faster.

 

[Papa Lazarou]

Yes you can get ready to use unflavoured e-liquid. For example, HealthCabin sell unflavoured PG or VG bases with nicotine in 11, 18, 24 or 36mg/ml strengths at a very economical price. If your preference is for no flavour you can use these straight out of the bottle. Note these ones IMO have a bit of a peppery taste from the nicotine.

If you want to mix yourself from a higher strength nicotine base you can also do this. Be careful when dealing with stronger nicotine mixes, always remembering it is a poison. You can use VG, PG or PEG400 (polyethylene glycol) depending on your preference or a mixture, e.g. 80% PG, 20% VG is quite a common blend. VG is a thicker liquid and produces more vapour, but has a naturally sweet taste, carries flavours less well and has a reduced throat hit compared to PG. PEG400 is I think the most flavour neutral. Alcohol if used would typically be added up to about 5% and helps with throat hit. With pure VG, de-ionised water is usually added to thin out the liquid as it is too thick otherwise, or you could just vodka etc.

 

[rolygate]

First, I'd try to locate a supplier that will fix this for you, before you start trying to reinvent the wheel. There are a bunch of specialist e-liquid suppliers here that will send you whatever you want, and to me this sounds like a better idea than DIY as a beginner.

The quickest way for you to move ahead would be to just buy Ecopure liquid from Intellicig, all the flavors are extremely mild if not 'invisible' to most vapers. They do strengths up to 30mg in normal quantities, or 36mg in 500ml. If you get some of their Ecopure Mild, for me it's not possible to distinguish it from unflavored base. Their 'Fresh' is basically unflavored plus the tiniest hint of menthol. 'Rich' is what others might call a super-light hint of tobacco flavor.

It's all VG of course, try a small bottle to see if you like it, it's the nearest thing in vaping to 'hypoallergenic'. Alternatively, use it at 5 volts plus strong flavors added and you can get all the hit you want.