• This forum has been archived

    If you'd like to post a thread, post it here instead!

    View Forum

Rba users

Status
Not open for further replies.

CraftyZA

Senior Member
ECF Veteran
Verified Member
Aug 27, 2013
247
98
47
South Africa
www.fdev.co.za
Do we have any rba users in centurion/pta area that can assist a rba n00b?
Got my rsst from Melinda today... YAY!!!!
I've watched about every rsst coil vid on youtube, but cant seem to get it right.
I pulse it, move it, fiddle it, hot spots will not disappear. I Only have .16, .12, and .32 kanthal/ni-crome wire. I tried lightly oxidize
Aiming for just over 1 ohm. 1.3(ish)
 

CraftyZA

Senior Member
ECF Veteran
Verified Member
Aug 27, 2013
247
98
47
South Africa
www.fdev.co.za
I want to try and set it up with some one so that I can see how to get rid of the hotspots, and too see if it is possible to get a 1.3 ohm coil with the wire that I have. Like I said, I've watched plenty videos, and the basic tricks does not seem to work?
I'm missing something somewhere that is not shown in the videos I think.
 
If you guys have any RBA questions I would be glad to help - I don't have a whole lot of experience with RBA, but I have done a ton of research and have built up quite the knowledge base.

Crafty, I believe your issue has been sorted?

Also you guys can take a look at Reddit's subforum on RBA http://www.reddit.com/r/RBA - just post what your issue is, your resistance wire you are using, the Atomizer and wick and Ohm reading and they will be more than happy to help - it is a pretty active forum and friendly too

Oh and if you can post a pic of your setup, then the troubleshooters on Reddit can have a look and give you a nice breakdown of what they think you can try
 
Last edited:
Status
Not open for further replies.

Users who are viewing this thread