RBA's and the Vape Safe Fuse 2

[RJB777]

Hello I have a question to anyone who uses the vape Safe Fuse 2 and their rba ect. on a Mech.

I am wondering if any of you have tried it with a 1 Ohm coil and had positive results? Supposedly the vape Safe Fuse 2 can start to trip at 3.5 Amps and will trip at 6 Amps no matter what.

If I am using a fresh batt with a 1 Ohm coil, this pulls 4.2 Amps on a full charge, which is over the minimum load but under the maximum. I am concerned that I will have to wrap a higher resistance coil to get down to the 3.5 amp draw.

If I wrap a coil at 1.2 Ohm it drops the Amps to 3.5 on a fresh battery but I am going to lose a lot of power and I dont want to, so I am hoping someone has had good experiences, or possibly some advice?

Thank you in advance!

 

[GratefulVaper]

I am using a vape safe 2 in my Magneto v2 with MNKE 18650 & AW imr 18650, on coils as low as 0.6 Ohm with no tripping of the fuse or (VS2)incidents of any kind...

 

[t8kiteasy]

I am not sure about the Vape Safe 2 fuse,i have the Holocron ShortStop fuse and have tried it in my mech's with a .5 and up to .9 coil,and the fuse will not let the MOD fire at all.

 

[LarryPer]

Mine died at 1.4 and can't be re set

 

[RJB777]

Well I was supposed to get my New RDA and fuse and batts today but USPS didnt deliver on time =[
Looking forward to tomorrow now though lol

 

[RJB777]

Got my Igo-L today and my Vape Safe Fuse 2, Coil @ 1 Ohm is firing just fine, though i think i might drill this air hole out some

 

[State O' Flux]

Ive been using these cheapo, $2.50 fuses that I buy a half-dozen at a time. The (seem to) work down to 0.6Ω before they let go. When they go though... they're gone. ;-)