RDA continutiy

[daveydee89]

Maybe Someone Can Help Me Out. I May Be Over Thinking This.

I Got A Trident Clone. Waiting For The Itaste Vv To Be Able To Check For Shorts And Such. I Have A Ohm Meter A Little Electrical Knowledge, I Couldn't Wait.

PreinstalleD coils read At 2 Ohms So Far So Good. Then Started Checking For Continuity On The rda For DOA. It Is A Clone My First RDA For Practice Building coils. (Next Check Mod But Dont Have A Fancy APV To Make Sure Every Things Ok. Yet!) Back To Subject I Only Have My Egos Thus Far.

Im Getting Continuity From The Poles To The Deck? Is This Supposed To Happen? I Just Figure They Were Supposed To Be Insulated From The Deck. Dont Wanna Catch A Shock If I Can Help It Tho It Shouldn't Be Too Bad! Lol

Can Some One Please Enlighten Me.

 

[K_Tech]

The two outer poles should show continuity to the deck, they are the negative posts. The center post should ONLY show continuity to the bottom of the 510 connection. If it also shows continuity to the deck, something is wrong.

 

[madberry]

Are you checking the continuity with the coils attached? In that case your meter will always beep. This is supposed to happen as the coils connect everything together....

 

[K_Tech]

Are you checking the continuity with the coils attached? In that case your meter will always beep. This is supposed to happen as the coils connect everything together....

Hadn't thought of asking that; it's true, if the coils are connected, everything will show continuity. You need to check continuity with the coils removed.