Rda for nickel build?

[ballerford]

I've been using an enigma rda and plume veil but constant have to rewrap because I break the leads when securing them any help with this issue or even an easier rda to work with would be great.

 

[caferacer]

Try sanding down the bottoms of your post screws. Doing so should remove any sharp edges, thus making it more difficult to break the leads when you're securing your coils.

 

[ballerford]

Thanks I've also noticed that if the posts I use aren't stainless steel the wire tends to char. For example in my zenith it's just fine but in either the plume or enigma it burns

 

[drunkenbatman]

Hey mate!

Ignore the post-holes, and just wrap around the screw heads. e.g., raise them up, wrap-around, tighten down. It can not only help with working with the nickel, but apparently helps temp-sensing work better.

OG -rapping baby.