RDA rda jumping ohms

[dallyllama]

hi, if someone could help me that would be great, so when I use my little boy clone rda on my ipv3 it will read something like .3 ohms then the next time I fire it will be like .6 or even 1.2 . and when I fire my atlantis v2 or arctic tanks the ohms are fine, they don't jump. does anybody have some advice on this. thanks

 

[James Wilson]

Could be an issue with the connection. Perhaps the wires are touching the sides, each other or at just loose from the screws. I also had an issue with this on my rebuildable rba that came with my sub-tank mini. Not only was it wicking bad but I found the resistance kept changing a lot. Since your using an RDA, I suggest just rebuilding the coil and rewicking it if you can't figure out exactly what is causing it. Also be sure there is no e-juice stuck between the rda and the bat. Sometimes it can get down into the connector piece and cause issues.

 

[dallyllama]

okay thank you so much

 

[James Wilson]

Your welcome. I am far from an expert but i have learned much in my time here.

 

[EBates]

Sounds like a mechanical connection problem. Check:
Center pin (510 connector) screw
Coil connections
Tank secured to your mod

 

[dbrandt01]

Have you cleaned the contacts of the atty? That's possibly a problem.
Could be a loose screw. You could've clipped the lead by tightening too tight.

 

[sonicbomb]

My money is on a partially clipped lead, or a loose post screw.

 

[Robert Cromwell]

Does not have nickel wire in it does it?

 

[dhood]

Definitely a connection issue. something is loose. you may have to break it all back down until you find it.