RDA on an Innokin VV V3?

[Wonkie]

I am wanting to try out an rda. I am looking at either the Igo-L or the Igo-S as I want to start with something inexpensive. Has anyone used either of these on a VV V3? I think they should work as long as I keep the resistance above 1.2 ohms. Wondering if anyone has had any luck with a similar setup.

 

[Bodog]

I really am not entirely sure what this VV V3 is but I will tell you that I have absolutely loved my switch from my carto set up to my rda. Im using the IGO -W which is pretty legit and pretty easy to use. The reason I switched to rda was I tried a friends and instantly noticed the nic buzz that I got of the RDA in comparison to a carto set up. I almost feel like any set up other than a RDA where I can use a higher nicotine doesnt cut the cake for me and leaves me chasing after my nicotine buzz and wanting a better set up. I dont entirely understand why when you use a RDA you can only go past like 8mg or you will get nicotine sick, but I feel it really gives me the fix im looking for.

 

[RuDawg7890]

I just received the IGO-W yesterday, and I'm in love so far! I set out for the IGO-L at first, but it was suggested by many ECF members to get the W to have the dual (or more) coil option.
Plus, the W has holes in the posts for your wire, while with the L & S you have to connect your wires around the screws. The holes make it easier.
Either should work fine on your device.

 

[State O' Flux]

I think they should work as long as I keep the resistance above 1.2 ohms.

That's it. They have a 3.5a limit... do the math for 1.2Ω/11 watts and you get 3 amps... so, if the 3.5 limit is accurate, a 0.5a safety margin.