RDA with threaded topcaps

[Spacedoutart]

Hi Guys. As some as you know Ive been doing rebuilds for quite a while now. I was going through my vape drawer and found my first rebuildable. Phoenix Bulli Clone. I noticed that the top cap was threaded on, instead of held by orings. That got me thinking what other RDA have threaded top caps? They didnt come off in my pockets which happens once in a while with my other RDAs. However the problem with my original phoenix was that the airhole was lined up with a post. You had to break the press fitted threads to get it properly lined up with the coil.

 

[Jazzi Mike]

The Reomizer has a threaded top cap, so the Triangle will as well.

 

[Rmcgloth]

https://www.fasttech.com/products/1439900 this does as well

 

[spaceman84]

The Immortalizer has a threaded top cap and the best flavor money can buy.

Sent from my HTC6435LVW using Tapatalk

 

[super_X_drifter]

I recently picked up an Aero BF (bottom fed) from dragonfly ecigs. On paper it resembles a chalice. In life it is significantly taller. It's a decent quality SS RBA and it vapes on par with the chalice after drilling an airhole in the top cap. It comes with air thru the 510

Again, what relegates it to a non go to RBA for me is the height of it.

But it has a screw on cap. I believe it can also be had without a feed hole in the bottom so it is a dripper.

Here's a pic (left to right) of the aero, chalice and REO RM2 :

Here's a pic of the internals of the Aero:

 

[Peppie]

AIOS has a threaded top cap in the dripper mode

 

[JD1]

The fatty v3 and clone has a screw on top cap. I just picked up the clone from fasttech. Todd has a review of it on utube.

I would recommend the immortalizer clone but judging by feed back on the forums, an awful lot of them have stripped threads in the the negative screw hole. Mind did and I sent it back. Great vape though, while it lasted.

 

[spaceman84]

Just don't get the fasttech version. Hcigar makes one too. Or replace the screws.

Sent from my HTC6435LVW using Tapatalk

 

[JD1]

Just don't get the fasttech version. Hcigar makes one too. Or replace the screws.

Sent from my HTC6435LVW using Tapatalk

Yeal, I am talking about the fasttech version and should of made that more clear. It's not the screw though, it's the screw hole.

Where would be a good place to get one?

 

[spaceman84]

Ah, you can get replacement parts for the immortalizer, but I don't know if the clone is accurate enough that they would fit.

Sent from my HTC6435LVW using Tapatalk