really hard/tight draw on 306 atty

[dnrtn2342]

Got these attys last week. They heat up but the draw is really hard. Then I debridged/dewicked one (first time) I get a th and vapor but still a hard draw anything I can do? These are joyetech 306 lr attys.

 

[babemomlover]

From my experience that is just how the 306's are.
Tight draw, with good vapor and flavor.

 

[six]

If it's too tight, you can hog out the air holes. A 1mm drill bit fits the two tiny little holes at the top of the threads. No drill necessary. Spinning the drill bit with your fingers is enough... and don't go too deep.

 

[MikeB]

If the draw on mine fills too stiff I just unscrew it a hair and/or loosen up the atty cover by pulling it up a hair. Most of the time its just that I over tightened it at the 510 connect.

Hope that helps.