Reccomended wire?

[Danny Shipley]

I have a ijust 2 mechanical mod and a velocity rda
as its a mechanical mod im quite unsure with a good wire and ohm to use

I'm after something that will produce good clouds and is cheapish to buy

 

[Continuity]

The iJust2 isn't a mech mod - it just acts like one in that it's not adjustable in power.

As for the build - that would depend entirely on the kind of vape that you're looking to get from your dripper.

 

[Robert Cromwell]

Found this about the Ijust2 kit.
Eleaf Ijust 2 Review - Vape Reviews You Can Trust
And this is included in the text/review of the KIT.
'The Eleaf iJust 2 kit comes with their standard 0.3ohm coil installed. They also have 0.5ohm and 0.15 Ni200 coils available separately if you like a tighter and cooler draw. '

NEVER EVER use NI200 coil with a non Temperature control mod.
Vape reviews you can trust?

With that minirant over.
Looks like the mod will handle down to at least a .3 resistance coil.

 

[djsvapour]

Unless you feel you need 0.3 then aim to make 2 coils at 0.7-1.0 ohm. For example; two coils of 0.8 makes a 'build' of 0.4.
I use 0.32mm / 28awg. 26awg is good to.

 

[Two_Bears]

I have a ijust 2 mechanical mod and a velocity RDA
as its a mechanical mod im quite unsure with a good wire and ohm to use

I'm after something that will produce good clouds and is cheapish to buy

IJust is a regulated mod.

I would recommend two wires

Stainless Steel has THR best flavor bar none. On most TC mods Stainless Steel can be used in both TC and power mode.

Kanthal only works in power mode.

 

[Robert Cromwell]

I do not think the Ijust2 mod is adjustable output.