I'm using a 50 watt invader mini and a mutation x V4. I want to make a dual coil build that will produce the most vapor. I'm not sure what resistance/gauge coils to use to get the max out of the 50 watts. I did some research but was not able to find a clear answer. Any advise would be greatly appreciated.
Recomanded coils for RDA
- Thread starter Brian Calef
- Start date
- th_trl_thread_readers 0
- Status
To get clouds you want low ohms (as low as your device can handle), 24g to 28g kanthal (may be different for ni,ti,ss) high VG and high watts. Clapton coils are all the rage right now so you might want to try those but you'll need large post holes because the wire is thick. Twisted 28g Kanthal works best for me.
I have a few builds that really shine at wattages around 50 however my favorite build to date for this range is a 26G Dual Coil, Wrapped on a 3/32 drillbit, 8 times on each side! If this type of build doesnt work out, I would opt for going for a single coil, trying what tmcase said above and go for a clapton build! Also, because your onlyu pushing 50 watts, while tempting to use wide open, the builds with function best with limited airflow! Good luck!
*EDIT* There is also this build that I made today for a customer that I think would work well for you! 24G 8 Wrap Dual Coil, 7/64th drill bit, ran at 45 watts. Great build and flavor is on point!
*EDIT* There is also this build that I made today for a customer that I think would work well for you! 24G 8 Wrap Dual Coil, 7/64th drill bit, ran at 45 watts. Great build and flavor is on point!
Last edited:
- Status
