Recommend a good atomizer pls

Status
Not open for further replies.

darkhood

Ultra Member
ECF Veteran
Dec 22, 2012
2,885
1,455
PA
Hi, I have the micro ego kit seen here - KGO batteries 1100mAh

It didn't come w/ an instruction booklet so I have no idea what the voltage is...I know it's 350mah but I'm looking for an atomizer to get that will work well with it so I can try sample flavors w/ a drip tip - a lot of the sites say stuff like "don't use w/ 3.7 volt batteries or higher" though so I dunno exactly what to get since I don't know the voltage. I was thinking a single coil 1.5 ohm LR atomizer would work but figured I'd check here first and see if anyone has any suggestions. Also a good site to buy a couple of them w/ low shipping would be great. Any help would be greatly appreciated. Thanks :)
 

sawlight

Vaping Master
ECF Veteran
Verified Member
Nov 2, 2009
7,408
10,985
Kansas
You can use 1.7 ohm, but the 2.0's are a safer choice. Don't use anything below 1.7 though! Hopefully it wont fire, best case, or it can ruing your battery, worst case.
Off the charger your battery will have 4.2-4.3 volts and drop almost immediately, then settle out around 3.7v and slowly drop from there.
 

Jerms

Vaping Master
ECF Veteran
Jan 1, 2011
9,252
25,832
Fargo
When I used fixed voltage ego type batteries I prefered 1.8 or 2 ohm atties. If it's unregulated it comes off the charger pretty high, and 1.5 ohm was a little too hot for me. If it's regulated at about 3.4 volts the 1.5 was perfect. For a reliable atty tho a little more expensive I would suggest Ikenvape or Cisco spec from avidvaper. They test their atties and the stated ohm is very accurate. There's some great cheaper options but the ohm range compared to stated range is an issue. Those are best if you have something to read the actual resistance and variable voltage to adjust as needed.

Sent from my LGL55C using Tapatalk 2
 
Status
Not open for further replies.

Users who are viewing this thread