• This forum has been archived

    If you'd like to post a thread, post it here instead!

    View Forum

Recommendations

Status
Not open for further replies.

Fuffles

Full Member
Verified Member
May 9, 2015
45
11
31
Currently using an ipv 3 Li. Not too bad but for staters might not be that worth it? You rarely use more than 100W. Maybe that's just me cause I still suck at this. Haha.

Im also using a Subtank Mini. It's really good but like WarA said, be careful of spitting juice. Mine is also leaking quite bad (Out the tank itself and sometimes the airflow channels, looking into it).

Hope you get what you are looking for! Cheers!
 

WarA

Super Member
ECF Veteran
Verified Member
Jul 24, 2015
487
238
Currently using an iPV 3 Li. Not too bad but for staters might not be that worth it? You rarely use more than 100W. Maybe that's just me cause I still suck at this. Haha.

Im also using a Subtank Mini. It's really good but like WarA said, be careful of spitting juice. Mine is also leaking quite bad (Out the tank itself and sometimes the airflow channels, looking into it).

Hope you get what you are looking for! Cheers!
I have two sub tanks one with old horizontal occ one with vertical occ, none leaked. Did you check whether it's because of flooding? (Typically caused by too little wick) so far what works for me is 2x diameter of coil of kohgendo cotton followed by cutting the cotton on the edge after the rubber seal, then just fold up to slot the cap on and tuck cotton in.

If the leak is happening at the glass area then probably you'll need to replace the o ring or the glass itself.
 
Status
Not open for further replies.

Users who are viewing this thread