Request for help with a Big Dripper

[drippaboi]

I'm currently playing with a Big Dripper, authentic if it makes aq difference for this problem, and the copper positive pin looks almost completely flush with the surrounding 510 threading. Haven't had a problem so far but I'm a little concerned it may short if used with another mod. I can't see and obvious way to adjust the pin so Im wondering if this is normal for this atomizer, or if something can be done to ease my mind a bit. thanks!

 

[MythDrago]

some just don't have the adjustale pin and using on a mech mod can be a issue i.e(causeing a short) my plume veil is same way with my 4 nine clone I can use it with a button top battery but not a flat top. a good question is what kind of mods are you or planning on using it with.

 

[drippaboi]

mech mods mostly. so far it hasn't had a problem on its atmizoo lab 65, and it's usually used with a Vulcanizer where it has had no problem on any other mod thus far. Helpful to know to be mindful of the issue though, thanks.

 

[MythDrago]

ok did a look up on what your using looks like with that set up you really shouldn't have a issue but its allways good to no random things can happen

 

[dravell]

Just dont use it on a hybrid. Any standard mod with adjustable 510 shouldnt cause any issues since theyre usually smaller diameter than the negative threads of the atty. The only time you would have a problem is with a hybrid connector since itll hit both the negative and positive of the atty causing a hard short.
My Big Dripper has a near flush 510 also, but its out far enough where it doesnt cause an issue with a hybrid connection, your results may vary though so just be careful if you do go that route.