RIP first box mod

Status
Not open for further replies.

dogpound9219

Senior Member
ECF Veteran
Jan 5, 2011
106
5
33
South jersey
Today I am sad to report that my first box mod suffered an accidental overheating. LOL ya it seems while to was in my pocket in the car i must have been sittin on the button or something and it overheated to the point were the plastic around the atty connector was melting. So all in all I had to trash it, this just gives me an excuse to make a new mod :D
 

MadmanMacguyver

Ultra Member
ECF Veteran
Feb 8, 2011
1,473
607
Dallas Texas
poor mod...I hope it donated its organs...so that another may live...

Master switches are important but often get forgotten to be used...

if the mod is setup to power down by way of the inhibit pin from internal temp rising beyond a certain point well..mod saved...of course that only helps if its a regulated mod...

oh dang I just hinted at one of my tricks...oh well its for a good cause...
 
Status
Not open for further replies.

Users who are viewing this thread