Reo and Rm2 user for quite some time. When I change cotton wick about every 3 days I check the screws on top of the posts just to make sure they aren't loose, the other day the screws were fine just for the hell of it, I took my pincher pliers and just turned the positive post a little bit, no real reason. Went to vape and noticeably more clouds. I didn't originally tighten post for this reason, but there you go ( tightened the positive post). Anybody else experience this? Normal? Something to always check? Thanks.
RM 2 and the posts??
- Thread starter hubseven
- Start date
- th_trl_thread_readers 0
- Status
yea man, I actually check the post screws once or twice a day, so far with the RM2 atty I have not found them to become loose after the build is complete and running. I can't say the same about my other rba's. my Helios and Omega do get loose with use sometimes.
Actually, he's saying to test/tighten the actual post. I do check that my post screws are tight, but never thought to check/tighten the actual posts. It makes sense, though, because they're threaded and just screwed into the base. My post screws do loosen up occasionally, especially when I'm using 28 gauge wire. Not so much with 30 gauge.
This makes sense to a point. Worth checking them from time to time. However, doesn't the coil act in effect as a "keeper" (to use a mechanic's term)? If your coil hasn't stretched or become bulbous, your posts can't have rotated, right?
- Status
