RSST New Tank Material Discussion

[Red_Bird]

I got all excited reading the thread title and thought the designers of the RSST rba got up to pyrex speed...

I'll wait till they do.

 

[Symbolik]

What will the tank look like when it cracks? and what kinds of flavors are known to be tank killers?

 

[fooey]

I sanded the 510 pin / pole on my new rsst from recent batch and its ss. The washer rusted up from washing with water though. I'm not getting a lot of vapor with my new rsst's, seems like a very weak vape probably due to the tiny airhole

Sent from my PG86100 using Tapatalk 2

 

[Rule62]

I sanded the 510 pin / pole on my new rsst from recent batch and its ss. The washer rusted up from washing with water though. I'm not getting a lot of vapor with my new rsst's, seems like a very weak vape probably due to the tiny airhole

Sent from my PG86100 using Tapatalk 2

Most RBA users seem to agree that the air hole is a bit small. Drilling it out helps vapor production. I drilled mine out to 1.2mm, Some folks are going up to 1.5mm or 1/16".

 

[pmar4015]

Has anyone replaced the center post screw/post with a brass one so as to improve conductivity? If so, what size is it?

Thanks

 

[HandbananA]

Has anyone replaced the center post screw/post with a brass one so as to improve conductivity? If so, what size is it?

Thanks

dunno nothing about that, but I did lose the friggin plastic positive pole isolator.

 

[HandbananA]

Most RBA users seem to agree that the air hole is a bit small. Drilling it out helps vapor production. I drilled mine out to 1.2mm, Some folks are going up to 1.5mm or 1/16".

I ended up just drilling a second hole above the stock hole, the stock hole is way too low on the coil for me.