RTA Suggestions
- Thread starter timreams
- Start date
- th_trl_thread_readers 0
-
- Tags
- rta suggestions
- Status
Dual coil mtl? That makes it hard. There are several well regarded single coil mtl RDAs out there if you’re not that set on dual coil though.
In that case I present the ares for your consideration. It’s well liked locally by many mtl vapers here.
Digiflavor Themis looks like a winner. Don’t have one yet but it’s being seriously considered. Check it out, it ticks all your boxes and looks nice as well.
If you want a dual coil MTL vape, you could try "the Russian.... version whatever." I have a "Russian 100" I think it is, and it was the first RTA I set up. I really don't recommended it, other than to say a) it has more parts than my car and b) I really learned a LOT. LOL. Painfully, but I learned a LOT. I only set it up once, and haven't vaped it since. This is mainly because there are so many nice single coil RTAs these days that are far easier to deal with and equally excellent in flavor, in my opinion.
The Ares is a great choice, it's a flavor machine the capacity is nice and it is a very easy first build. I liked mine enough to purchase a second one. I am also very partial to the Siren V2, both the 22 and the 24 mm diameter versions, although fair disclosure, some folks don't find it as flavorful as some other RTAs. I like the flavor in mine, but I run it wide open with airflow it just seems to vape best that way. It's also a juice drinker in my opinion, but for me to get the right flavor I had to go more open airflow and slightly higher in wattage. The berserker is another great tank for flavor, although many folks do struggle refilling it and find it easier to use bottom fill to avoid leaks, gurgling, and flooding This tank has the tightest draw out of the three, but it is a flavor machine, and not a very thirsty tank. The draw is really quite tight, sometimes almost too tight. It's a slightly more complex setup, but still on the easy side.
Also good candidates, the doggy style (most people using these will get a clone from Fasttech as the clones are regarded as equally good and in some ways better than the original. There are a couple different clone types, so you'd probably want to pay attention to if you want an airier draw than a tighter one. Most people rave about the flavor and find it an easy setup. I did not although I have a fine motor tremor and that particular build deck, which uses flat head screws, was just particularly difficult for me, but my results aren't typical. You could certainly get the Kayfun prime, but I don't think that (or the doggy) would give you quite the capacity that you desire.
I use simple round stainless steel builds with Rayon in my RTAs and have had been having pretty good success of late, at anywhere from about 0.8 to 1.2 in terms of resistance. There are some great, not too expensive items out there these days, so it's nice to have options.
Best of luck with whatever you decide on!
Anna
The Ares is a great choice, it's a flavor machine the capacity is nice and it is a very easy first build. I liked mine enough to purchase a second one. I am also very partial to the Siren V2, both the 22 and the 24 mm diameter versions, although fair disclosure, some folks don't find it as flavorful as some other RTAs. I like the flavor in mine, but I run it wide open with airflow it just seems to vape best that way. It's also a juice drinker in my opinion, but for me to get the right flavor I had to go more open airflow and slightly higher in wattage. The berserker is another great tank for flavor, although many folks do struggle refilling it and find it easier to use bottom fill to avoid leaks, gurgling, and flooding This tank has the tightest draw out of the three, but it is a flavor machine, and not a very thirsty tank. The draw is really quite tight, sometimes almost too tight. It's a slightly more complex setup, but still on the easy side.
Also good candidates, the doggy style (most people using these will get a clone from Fasttech as the clones are regarded as equally good and in some ways better than the original. There are a couple different clone types, so you'd probably want to pay attention to if you want an airier draw than a tighter one. Most people rave about the flavor and find it an easy setup. I did not although I have a fine motor tremor and that particular build deck, which uses flat head screws, was just particularly difficult for me, but my results aren't typical. You could certainly get the Kayfun prime, but I don't think that (or the doggy) would give you quite the capacity that you desire.
I use simple round stainless steel builds with Rayon in my RTAs and have had been having pretty good success of late, at anywhere from about 0.8 to 1.2 in terms of resistance. There are some great, not too expensive items out there these days, so it's nice to have options.
Best of luck with whatever you decide on!
Anna
The Aromamizer Supreme v2 can do both single/dual, the newer vanilla aromamizer is also a decent size. if you dont mind vaping a soup can, the Titan holds 28ml and can do single/dual/triple/quad coils, but its 41mm and would be a tough MTL.
if you are ok with spending a bit more, the Taifun series are 5ml and great mtl devices.
if you are ok with spending a bit more, the Taifun series are 5ml and great mtl devices.
- Status
