Looking for a rebuildable tank. I am not sure which would work or look best flush wise on a 22mm mech. Any advice?
Russian or Kayfun for Mech use...
- Thread starter Siochanai
- Start date
- th_trl_thread_readers 0
- Status
Horizontal Flush-itude> Check. Both "authentic" atties are outer-wise 22mm in diameter.
Vertical Flushingness> Does yer mech have an adjustable atty-side 510 positive pin? If yes, Check too. If not.....then as far as I know only the Russians these days have truly adjustable posi-pins. So with a kayfun> Maybe, cause you could get lucky. With a Russian/R91 > Check three!
Are either of them any good? Well....you didn't ask, so I wont burden you with my current somewhat less than eager post-dispositioned opinion of them.
Cheers.
Vertical Flushingness> Does yer mech have an adjustable atty-side 510 positive pin? If yes, Check too. If not.....then as far as I know only the Russians these days have truly adjustable posi-pins. So with a kayfun> Maybe, cause you could get lucky. With a Russian/R91 > Check three!
Are either of them any good? Well....you didn't ask, so I wont burden you with my current somewhat less than eager post-dispositioned opinion of them.
Cheers.
Last edited:
- Status
Similar threads
