I've got a black and red Wismec Releaux RX200(really hope I spelled that right) with deadpool software, and it only goes up to 225W, I was wondering if it's supposed to max out at 225W or 250W. I was told the max is supposed to be 250W, but everybody knows people are such an unreliable source of accurate information, so should it be maxing out at 225W or 250W?
RX200 Q+A
- Thread starter KThurm
- Start date
- th_trl_thread_readers 0
-
- Tags
- rx200 rx200 firmware
- Status
I hope you have spent the time to understand battery marriage and safety
Reuleaux RX200 Upgrade Firmware 3.10 Version Launching - Wismec Electronics Co.,Ltd
Reuleaux RX200 Upgrade Firmware 3.10 Version Launching - Wismec Electronics Co.,Ltd
It will do 250w with certain resistances then drops as you get away from them. There's a chart somewhere that shows what does what wattage.
It says .1-.32 ohms for 250w, Reuleaux RX200 Upgrade Firmware 3.10 Version Launching - Wismec Electronics Co.,Ltd
It says .1-.32 ohms for 250w, Reuleaux RX200 Upgrade Firmware 3.10 Version Launching - Wismec Electronics Co.,Ltd
The RX200S I own would not allow going up past the Atomizers Max. If you want to see it go to 250W remove the atomizer.
Thank you for actually providing valid and helpful feedback that is exactly what I requested, I am running 24 gauge A1 kanthal with 8 wraps around a 3mm shaft(I did 8 wraps to ensure it was well above 0.10 ohms, I don't want my batteries to vent or worse yet to have so much money literally blow up in my face) and the RX is reading 0.36 ohms meaning that 225w max makes perfect sense. I don't use it at max wattage, I don't go past 180W and I usually roll around 150W-175W. Thanks again, is there done way I can mark this as the top reply? I'm new to this site so I have almost nothing figured out.
I'm using married samsung 25R 18650's each with a 4.2V maximum capacity all charged with an external 4 port bay charger and only used in the RX200 together meaning they charge and discharge equally keeping them married, yes I've studied battery marriage and battery safety, if I have batteries that get a divorce(or as you would most likely say become un-married) I either throw them in a garbage can or give them to my friend who has an IPV D2 because it's a single 18650 mod meaning he doesn't need married batteries, he just needs a battery.
The RX 200S requires the 4.10 Version of the firmware to hit 250 Watts. I have the 4.0 installed at present and limit is 200W.
- Status
Similar threads
