Sampling ejuice

[vaper1960]

Woops... your pods have a fill valve (which is nice) but I don't think a blunt needle will work. One other option is to get some unflavored juice. Fill your pod half way with the "test" juice and if you don't like it, top off the pod with unflavored... at least it will dilute the flavor. Vape that, then fill with another juice.
Please be aware of the nicotine strength of the juices you use... do you know what your juices are (3mg, 6mg, 12 mg, ect)? Some are rated like 3%, 5%... those are 30 mg and 50 mg (that will make you sick if used in a RDA) I'm surprised nobody asked you about that.

 

[Z-Lee]

I was just going to say, I think an RDA is a bit much to "test" juice if they're a drop in coil user. I would say if you pull the coil, prime it with the new juice some, and then as vaper1960 mentioned, just fill to the bottom of the coil wick slots in your tank (the open slots in your coil that the wicks use to absorb the juice) - should be enough to just test the juice.

There will be a short period of time in which you'll be tasting the juice you previously used in your coil and the new juice - it should eventually be vaped through though.

 

[vaper1960]

@Z-Lee , it's a pod and the coil can't be replaced.

 

[Z-Lee]

@Z-Lee , it's a pod and the coil can't be replaced.

Ahh, I missed that part. Still though - filling it up to the base of the wick openings on the coil and rolling it around would eventually absorb the small amount of juice in there - enough to take a taste test.