Scratching head over here...Stardust/Battery problem

Status
Not open for further replies.

BethAnn

Senior Member
ECF Veteran
Verified Member
Aug 12, 2012
217
47
Over Yonder, Texas
www.facebook.com
Hubby and I have the same exact battery....and this was done after they were both fully charged. Anyway...i picked up hubs battery and put my stardust on it. The draw was extremely tight???? Almost impossible! I put it on my battery and the draw is not tight at all. I put my vivi nova on his battery and the draw was fine. His stardust works fine on it too. Only my stardust will not work on his battery????? What in the world could be going on here?
 

X P3 Flight Engineer

Ultra Member
ECF Veteran
Verified Member
Feb 27, 2012
2,598
1,305
Moncton, N.B. Canada
The center post of his battery is a little lower and the Star Dust has to be tightened a little more to make the connection. This closes off the draw. Try pulling the center post up a little. A paper click prying side to side is the usual procedure.

Hopes this helps.

Relax, Enjoy!


Edit: If that doesn't help, try pulling the center pin of your Star Dust down a little. Put something in the center air hole and twist and pull slightly. A little is all it takes to make a difference.
 
Last edited:

BethAnn

Senior Member
ECF Veteran
Verified Member
Aug 12, 2012
217
47
Over Yonder, Texas
www.facebook.com
Oh my gosh xp3...I did what you said. I got a paper clip and pried up the center of the battery. I did it once and put the stardust on it but it didn't work. I pried it up again and didn't tighten the stardust down so tight and it worked! Lots of vaper too. I just hate having something that doesn't work right...LOL, but you certainly helped me with this one and it's amazing that the first person who responded, which was you...solved my problem. I would be so lost if it wasn't for this forum! Thank you so much!!!

The center post of his battery is a little lower and the Star Dust has to be tightened a little more to make the connection. This closes off the draw. Try pulling the center post up a little. A paper click prying side to side is the usual procedure.

Hopes this helps.

Relax, Enjoy!


Edit: If that doesn't help, try pulling the center pin of your Star Dust down a little. Put something in the center air hole and twist and pull slightly. A little is all it takes to make a difference.
 
Status
Not open for further replies.

Users who are viewing this thread