Screws Missing

[bacawax]

I was changing my cotton and coil for my kangertech subox mini, and I dropped the screw for my rda. Couldn't find it back. Any idea where I could find the same exact small screw in SG?

 

[Karstine]

Isn't the small screw provided as a spare?

 

[Robert Cromwell]

Isn't the small screw provided as a spare?

Yep each of mine had one in the spare bag.

btw you do not have to remove the screw all the way just back it out just enough to slide the sleeve up.

 

[bacawax]

Isn't the small screw provided as a spare?

Yep each of mine had one in the spare bag.

btw you do not have to remove the screw all the way just back it out just enough to slide the sleeve up.

Nope, they only provided two spare screws for the coil, which is bigger than the one im looking for

 

[Robert Cromwell]

Nope, they only provided two spare screws for the coil, which is bigger than the one im looking for

Mine have 2 coil screws and 1 tiny housing screw.

And sorry I have no idea of the screw size nor where to get one.
Might try a jeweler that repairs clocks and watches?

 

[bacawax]

Mine have 2 coil screws and 1 tiny housing screw.

And sorry I have no idea of the screw size nor where to get one.
Might try a jeweler that repairs clocks and watches?

quite difficult to get the screw i guess..

 

[Karstine]

quite difficult to get the screw i guess..

Blutack the screw hole and the measure the height of the Blutack that went into the hole. Usually screws are measured by depth and diameter. As long as your depth is accurate and your diameter is close, you can fit the screw in there

 

[roy69]

Can you please specify which exact screws you are taking about? Is it the screws that hold the coil or the one to hold the chimney in place?

 

[bacawax]

Blutack the screw hole and the measure the height of the Blutack that went into the hole. Usually screws are measured by depth and diameter. As long as your depth is accurate and your diameter is close, you can fit the screw in there

Will try this and update you guys

Can you please specify which exact screws you are taking about? Is it the screws that hold the coil or the one to hold the chimney in place?

Not the one the hold the coil. The one holding the chimney

 

[bacawax]

Blutack the screw hole and the measure the height of the Blutack that went into the hole. Usually screws are measured by depth and diameter. As long as your depth is accurate and your diameter is close, you can fit the screw in there

both depth and diameter are 0.2cm. Is it correct?

 

[Karstine]

Should be around for there. Best to wait for an answer as I only know about the old version of the subtank. But it should be about right.

 

[anotherchap]

I was changing my cotton and coil for my kangertech subox mini, and I dropped the screw for my RDA. Couldn't find it back. Any idea where I could find the same exact small screw in SG?

Bro, if you are still looking for that screw, PM me