After all the good comments flying around regarding Carto's I went ahead and purchsed a 6 pack of KR808-D1 prefilled with menthol.
I only have RCR123A bats in 6v configuration and after trying with the KR's I found it might be a bit too much for them. I then came across the a thread talking about the cotton in Carto's getting burnt and that concerned me.
In the spirit of keeping trying I have since ordered a very large number of Carto's V2 in the 510 config directly from Microcig (China).
These Carto's do not have cotton in and therefore are less likely to harbour bacteria. They are designed to be refilled and has a special hole for a blunt syringe needle.
So my question is has anyone tried these new generation carto's and if so are they compatible with six volts?
Should they not be I am planning on picking up some AW IMR18650's from Lisa and will vape them in a 3.7 configuration.
I only have RCR123A bats in 6v configuration and after trying with the KR's I found it might be a bit too much for them. I then came across the a thread talking about the cotton in Carto's getting burnt and that concerned me.
In the spirit of keeping trying I have since ordered a very large number of Carto's V2 in the 510 config directly from Microcig (China).
These Carto's do not have cotton in and therefore are less likely to harbour bacteria. They are designed to be refilled and has a special hole for a blunt syringe needle.
So my question is has anyone tried these new generation carto's and if so are they compatible with six volts?
Should they not be I am planning on picking up some AW IMR18650's from Lisa and will vape them in a 3.7 configuration.


