sig150 battery questions

[VMGz]

Hey guys,

So I've been using my sigelei 150 with a married pair of 18650 Samsung 25r's. I vape around 50 W with a 0.3 ohm build and I notice when I pull the batteries out around 70% or so, they're at like 3.7ish volts. I know you're not supposed to discharge them past 3.6 so what's the deal? Why are they basically dead at 70%? Shouldn't I be able to run them down to around 15% before swapping them out? I just want to make sure I'm using the battery readout correctly, because if I keep having to replace them at 70% that's kind of lame.

Thanks,
Andy

 

[smokken22]

Hey guys,

So I've been using my sigelei 150 with a married pair of 18650 Samsung 25r's. I vape around 50 W with a 0.3 ohm build and I notice when I pull the batteries out around 70% or so, they're at like 3.7ish volts. I know you're not supposed to discharge them past 3.6 so what's the deal? Why are they basically dead at 70%? Shouldn't I be able to run them down to around 15% before swapping them out? I just want to make sure I'm using the battery readout correctly, because if I keep having to replace them at 70% that's kind of lame.

Thanks,
Andy

 

[smokken22]

I have same set up and I'm told the 150 will discharge at 11% I recharge at 27%

 

[dannyrl]

My 150 starts throwing the "Check Battery" message at about 20%. I haven't measured the voltages of my batteries when I pull them out to charge, but I've never worried about it. But I typically charged my 18650s at ~3.4 or ~3.5 V when I was on mechs.

 

[jeffjr464]

I have the exact same setup, my readout goes right to 0% before it dies, I have the newest version of the 150