Silver Bullet at 6v

Status
Not open for further replies.

FRANKSTER

Super Member
ECF Veteran
Oct 13, 2011
854
320
71
staten island, new york
Hello everyone...if anyone remembers me from a different thread...I would like to apologize because I did not realize that using caps meant that I was yelling. That said, I was wondering what is the best carto on the sb at 6volts.

I am using a boge 510 3ohm and the sb just fries it, I thought at 6v you needed to use a higher ohm cart. I would appreciate any help on this matter
 

dormouse

ECF Guru
ECF Veteran
Oct 31, 2010
12,347
1,611
Pennsylvania
I also didn't know you were using 6v.

I think in general you want your ohms of a single coil to be no more than 2.2 lower than your voltage, or at least any lower is darn hot and may give problems. See if you can find 4 ohm cartos. The 3 ohm cartos are good up to 5v or a bit more. But 6v may be a bit much. There may be some HV aka HR Cage cartos that are 3.4ohms - that would be a bit closer to what I think you need. But I am not an expert in high voltage.

See what these threads suggest and ignore any stupid suggestions that are obviously too low ohms (you know - the kind where somebody lists what they use on a totally different voltage)


http://www.e-cigarette-forum.com/forum/new-members-forum/225566-best-cartomizers-6v.html

http://www.e-cigarette-forum.com/fo...ssion/212476-recommend-me-cartomizers-6v.html

http://www.e-cigarette-forum.com/fo...-discussion/181271-cartomizers-6v-vaping.html
 
Last edited:
Status
Not open for further replies.

Users who are viewing this thread