Dual-coil cartomizer at 6volts on silver bullet??

[FRANKSTER]

I'm not a 100% on the RCR123a's ratings for 6v, but at 3.7 I user the AW IMR 18650 as well as the AW 2900 Protected batteries. They are both rated at over 6 Amps of power. I don't think the cartos even come close to taxing that limit. I think you should be fine with any variation of the AW 18650's for your 3.7 vaping and the if can get them get the Tenergy or AW IMR 3.0 volt RCR123a's. A good vendor is RTDVapor.com as he carries most, if not all of those batteries.

Thank you...from your statement, I will assume you use 2 aw imr 3v at 6volt on the sb. I have the aw 18650 at 3.7 volt. That works just fine. It is just the dc 1.7 with the rcr123a's at 6volts that is not firing up for me.

Thanks

 

[Dusty_D]

I have both, Tenergy and AW IMR's. I don't think you've mentioned what batteries it is that you are stacking, unless I missed it. This much I can tell you, the stacked 3.0's don't last for any decent amount of time with the dual coils. 3 - 4 hours maybe. So, keep a few on hand if you want to vape 6v all day.



Sent from my iPhone using Tapatalk

 

[FRANKSTER]

I have both, Tenergy and AW IMR's. I don't think you've mentioned what batteries it is that you are stacking, unless I missed it. This much I can tell you, the stacked 3.0's don't last for any decent amount of time with the dual coils. 3 - 4 hours maybe. So, keep a few on hand if you want to vape 6v all day.



Sent from my iPhone using Tapatalk

I am using the tenergy rcr123a 3volt

 

[Dusty_D]

Ok, so I know those work. I'm using them on a 1.7 dual coil right now. You sure they're charged right?! LOL.

Kinda stumped!!


Sent from my iPhone using Tapatalk

 

[FRANKSTER]

Ok, so I know those work. I'm using them on a 1.7 dual coil right now. You sure they're charged right?! LOL.

Kinda stumped!!


Sent from my iPhone using Tapatalk

Ok so we are using the same batteries on the sb at 6volts so the only thing that is different where I purchased mine. Yes, they are charged...lol...I fired up a 510 boge on it...that is the only difference I can see.

 

[jkoppk]

Get some of these batts and you will be good to go.I used 2 stacked in my ultramax with dual and triple coils and they drive them with plenty of power and no protection circuit to kick in.Also used them stacked on 1.25 ohm dual coils with no problems.Its the third battery down on the linked page.
Batteries

 

[FRANKSTER]

Get some of these batts and you will be good to go.I used 2 stacked in my ultramax with dual and triple coils and they drive them with plenty of power and no protection circuit to kick in.Also used them stacked on 1.25 ohm dual coils with no problems.Its the third battery down on the linked page.
Batteries

Thank you. I guess I will have to get a new charger for these. I have a tenergy for the rcr123a's that I have.

 

[mortios]

I've had the same problem. Try screwing the carto fully on and then back it off just a tiny bit just so its not fully snugged down but not to the point it's loose in the connector.

 

[FRANKSTER]

I've had the same problem. Try screwing the carto fully on and then back it off just a tiny bit just so its not fully snugged down but not to the point it's loose in the connector.

Thanks for the info...I will try it.