Simply put my Reo is not firing properly. I'm going to borrow my friends volt meter but i've tested the battery (AW 18650 2900mah) and atties (only use cisco 1.5 510 and 306) and both are fine. I clean the Reo in warm water about once every two weeks, and just applied noalox after applying about 2 months ago with the pack I got from Rob. Does anybody have any ideas as to why my Reo isn't putting up the full 3.7V to my atty? Help!
Slight issue with my Reo Grand.. help!
- Thread starter achu
- Start date
- th_trl_thread_readers 0
- Status
I do that. I clean my atty's every 2 weeks and use a new atty avery 4-6 weeks. I clean them with Isopropyl. Attys work fine. I threw them on my Darwin and they all read 1.4-1.6ohm. I'll try cleaning it out again but I did the same process last week and it didn't really do anything for it 
Hmmm.. I can order one and try I guess. I tried my battery and atty setup on my friend's Reo and it works perfectly
Reo was firing great for a few months and just last week it started firing funky..Hmmm.. I can order one and try I guess. I tried my battery and atty setup on my friend's Reo and it works perfectly
PM Robert (redeyedancer) if it all works on another reo.
For sure. I sent Rob a msg via the website already since I was too lazy to look up his email. My friend has the 2nd Reo Grand ever made by Rob and it's been kicking strong. I'm cleaning it again right now with an Iso soak and reapplying some noalox, but i'll PM Rob. Thanks guys!
He has had issues with the email on his site. If you PM him here, he will get back to you for sure!
- Status
