Anybody have a recommendation and where I should buy it? Preferably 22mm diameter and under $80.00.
Smallest 18650 Mech mod Clone.
- Thread starter marcyprojects
- Start date
- th_trl_thread_readers 0
- Status
The Russian made Red Rod, at 46mm is the shortest... but no clone, so at $75 before shipping (last price I recall), is a tiny bit out of your price point.
There are tons of Tarsius 4Nine clones, which are of course, 49mm. Of the ones listed here on FT... I'd suggest the $20 and over versions, as the quality is much better than the $15 ones.
As they are a close tolerance, hybrid type mech design with a floating button and no positive pin, quality is critical to good performance. These same mechs are being sold in the US for $40 and up.
I've seem to recall seeing a 44 or 45mm mech... but can't recall what or where. ;-)
There are tons of Tarsius 4Nine clones, which are of course, 49mm. Of the ones listed here on FT... I'd suggest the $20 and over versions, as the quality is much better than the $15 ones.
As they are a close tolerance, hybrid type mech design with a floating button and no positive pin, quality is critical to good performance. These same mechs are being sold in the US for $40 and up.
I've seem to recall seeing a 44 or 45mm mech... but can't recall what or where. ;-)
This is my smallest 18650 mod an Origin and a Aqua clone both available at FT for well with in your budget
Also available at FT A Gp Paps and Heron combo is about the same size
[/URL][/IMG]
Also available at FT A Gp Paps and Heron combo is about the same size
I was wondering how they were making a mod that was shorter than the Battery. Some sort of interdimensional partition perhaps?
In the clone market, I do think the 4nine clones are the shortest 22mm mods available.
Just a warning, though, it's not a good beginner's mod. The hybrid connection may not work with all atty's and, because of that, it's easier to cause a dead short than mods that use insulated contact pins.
Just a warning, though, it's not a good beginner's mod. The hybrid connection may not work with all atty's and, because of that, it's easier to cause a dead short than mods that use insulated contact pins.
hammer mod in 650 with kayfun 3.1 topper is slightly shorter than my vamo v3 in 350 with protank 3 topper. and for the hammer and kayfun i paid less than 50 bucks from FT.
- Status
