Smok big baby beast tank seal problem

[ozm8ey]

Okay so i was vaping just like i was for the last 3-4 weeks with my big baby beast tank and then all of a sudden the atomizer flooded. I put a new atomizer in and it flooded again. I though okay maybe the orings aren't on very good. so i took them off and back on and happened again. Then I went on youtube and found a massive problem which was the same problem as mine. There is a seal on the top of the tank where you fill the e-liquid and it seems it can expand and when it does so it flood your tank/atomizer.

This is a really bad design flaw in my opinion. I look on the internet and they cost like $10 for spare seal and orings with that much I'd might as well buy new tank. Luckily the tank has a spare one else I would have been screwed. Anyone else have a problem with it?

 

[SupplyDaddy]

You can get 5 sets of Clrane seals from fasttech for about 4.11 AUS.
$3.04 Authentic Clrane Replacement O-Ring Seals for Smoktech SMOK TFV8 Big Baby Clearomizer (5-Pack) 5-pack - 4pcs/pack at FastTech - Worldwide Free Shipping

I personally do not use the Big Baby, although there are about eight 8X's in the house. And there has not been an issue one with the top fill port seal in either the authentic or the clone versions used. But then, that is nature of top air flow tanks.

 

[ozm8ey]

You can get 5 sets of Clrane seals from fasttech for about 4.11 AUS.
$3.04 Authentic Clrane Replacement O-Ring Seals for Smoktech SMOK TFV8 Big Baby Clearomizer (5-Pack) 5-pack - 4pcs/pack at FastTech - Worldwide Free Shipping

Thanks I just bought 3 packs of them I was getting paranoid about my last seal becoming defective. I like the tank just don't like the rubber seal design.