smok gct coil wash tc mode

Status
Not open for further replies.

bwh79

Vaping Master
ECF Veteran
Verified Member
Dec 11, 2014
4,600
6,644
46
Oregon
Either will work, but having washed it in water I'd continue as alcohol (alcohols, plural, all of them) is less viscous than water.
"All" is a strong word. You know both PG and VG are technically "alcohols" (there's a hint in their chemical names: glycol, glycerol), right? And both are more viscous than water.
 

broncotr

Full Member
May 14, 2017
28
23
37
I think the thing with smok is they only provide Kanthal in there atomizers and therefore there is no temp control with the atomizers. They do put in SS coils in there RBA decks and they work well the smok unit I have.
I did some checking on the tank, rather old and it comes with the .2 ohm coil. Put it in wattage mode and try it 20 to 3O or so watts, then try again in temp nickel mode.
I just saw the "pico mod 450 f 50 watt" Pico uses different resistances and 50 watts is high for .20 ohms.
if i do not it does not hit the temperature lately i go down 45 40 watts but i use with a ramp up time
 
  • Like
Reactions: stols001

broncotr

Full Member
May 14, 2017
28
23
37
Yes. Alcohol dissolves the juice components better than water, or rather faster. But, being less viscous than water, it will have trouble soaking a water-wet wick. It would have been better if you had started with alcohol-- I recommend Everclear unless you have a neighborhood moonshiner, you don't want to use Isopropyl Alcohol-- but having started with water I'd stay there for this time. If you really want to try alcohol, drop the coil in a shot glass of it and leave it there for a day or more. The alc will mix with the water and invade the coil, but it'll take a while.
i will stay at water then:)
 
  • Like
Reactions: stols001
Status
Not open for further replies.

Users who are viewing this thread