Smok Magneto connection to atomizer to short. Is there a fix? I have a Nimbus atomizer

Status
Not open for further replies.

xtwosm0kesx

Ultra Member
ECF Veteran
Verified Member
Jun 30, 2010
2,298
3,160
Face down in the gutter, USA
That is correct. I was hoping someone would have a fix or an atomizer recommendation

Which version of the Magneto do you have? The V1 without the adjustable pin (i assume) or the v2 with the adjustable pin?

The best solution if its a v1 is to grab a v2 topcap for around ~$10 that has the adjustable pin, that should solve the problem.

Otherwise you could try extending the contact pin on the nimbus by setting the atty/510 connector in something hollow and round (like a beauty ring) then apply gentle but consistent pressure to the center shaft(on with the insulator around it) in the atty and it should push more pin out on the bottom. Move it a bit test etc until it fires, but beware its gonna change the way the atty sits on the KTS.
 

xtwosm0kesx

Ultra Member
ECF Veteran
Verified Member
Jun 30, 2010
2,298
3,160
Face down in the gutter, USA
i assume its a V1 because of the logo on the side, but there is a adjustment on the bottom of the center pin. It only moves down. Do you know where I can find a V2 topcap? I cant find a site that has them

This one should work, there is another version out there with 510 and ego threads too, but i dont care for the looks/style of it.

Magneto Adjustable Top Cap - Triangle Vape LLC
 
Status
Not open for further replies.

Users who are viewing this thread