I have a smok Magneto V2 tool laser cut from non-magnetic 304 stainless steel. It straddles both sides of the contact slots, so you can't create high contact points beside your slots when your loose fitting screwdriver jumps out of a single slot. Damaged or altered slots create high contact points which lead to hot spots in your contacts as all the current now has to flow through these tiny points that the whole contact surface area was originally designed to carry. NO MORE HOT BUTTON ISSUES! I designed the tool wide enough to fit barely inside the tubes without touching the threads, yet thick enough so it just fits inside the slots with 0.0025" of clearance inside the slot widths. Gently snugging the spanner end of the tool insures that the button firmly stays in place until your next cleaning. One small thin tool (1" X 3") dis-assmebles , re-assembles, and adjusts the entire unit! To properly clean your Magneto, your cleaning supplies should include: 91% Isopropyl Alcohol, Cotton Swabs (both available from the local dollar store) and a White Retractable Eraser found at your local office supply store. Check out my video at:
Please note my video was made with the aluminum prototype, the stainless production unit is an inch shorter as fits as I just mentioned above. See Picture below:
Please note my video was made with the aluminum prototype, the stainless production unit is an inch shorter as fits as I just mentioned above. See Picture below:
