smok xcube II TI temp control problems?

Status
Not open for further replies.

Luke S.

Full Member
Apr 15, 2016
17
20
31
I JUST did a firmware update and have not tried this yet since, but when I build titanium coils and set the temp control to TI(for the coefficient) it just doesn't seem to get hot enough. the max is 600 degrees Fahrenheit, and I know that titanium shouldn't even get that hot and still cant get the vape I want because it hits the temperature ceiling to fast. am I not building low enough? or to high? I just can not figure it out. I get almost no vapor production. every once in a while it would hit alright, but I'm not impressed and I'm pretty sure I'm just missing something. suggestions anyone? would also like to add that the xcube does not have a "joule" setting while in TC mode so I don't really understand how much power I'm using?
 
Last edited:
Status
Not open for further replies.

Users who are viewing this thread