Smoke X-priv kit problem

[AdiumY]

The 60-80 watts is too high. DO NOT pay attention to what is written on the coil. These are just recommendations by the coil makers designed so that the coils wear out faster and need replaced. Those high wattages are NOT required to use the coil.

Unless you turn the wattage down you will always have that burnt taste. Just try it. The members here at ECF are the most experienced vapers you will find anywhere.....you need to listen to the recommendations in order for your problem to be solved instead of insisting on using such a high wattage.

Hi thank you for your comments. if it's to hight, so what watts are good? it's also to hight even for rba? i have some friends with tfv12 and they use round 100-120 and say that it's awesome. so confused a little bit.. more over if make lower( f.e. 40-60) realy weak taste, less clouds and feelings..
so still dont undrerstand where is the problem)
thank you.

 

[Sugar_and_Spice]

Whenever you taste burnt ejuice that always means too much power is/was used. I still say to completely break down the tank and give it a good wash. Let it dry. Smell it to see if odor is still there. If it is then soak the whole tank(minus to coil) in vodka or alcohol for a few hours. And change out the orings. Burnt taste gets into them and its hard to get it out. Once the tank get that burnt taste it will never go away if you do not completely clean that tank and change the o rings.
And put in a brand new coil, making sure it is totally saturated with juice by dripping some juice on the cotton until it looks like a slushy. The reduce the power on the mod and take a pull. New coil/atomizers need to be broken in slowly so after the first puffs or so up the watts by 2 ot 3. Do this until you find your sweet spot(where it tastes the best to you)

 

[AdiumY]

SMOK prince coils can handle 70-100 watts easily and taste fantastic. .17 coil and 70 watts or more is no issue at all. .2-.4 coil would require more like 40-55 watts IMO. I don't use the RBA deck for prince and just buy their .17 ohm X6 coils. 70 watts is what I use to help the battery last longer but the coil provides better flavor at 75-80 watts.

Just yesterday evening puted new one coil inside. 0.4 Ohm with mentioned 40-100( best 60-80 watts)
As i see on web site X6 coil is 0.15 Ohm with 50-120(best-80-100 watts) ALso i got some info that replacement coil with 1 big "tube" works longer.. just now i try to use 60/40 juice, maybe 70/30 not good.. dont know. maybe really the problem with jiuce but it's reaaly hard to find "proper" juice cause we have millions)

 

[AdiumY]

If you have another mod I'd try that with the tank and try to eliminate it being the mod or the tank. If your using drop in coils and a rba with the same problem I'd think it's the juice or the mod.

Hi, Yes i have wismerkrx200 and original TFV12( not prince) also. i tried to put prince on wismerk and it seems to me that the same problem.. juice i try several. SOme frined use jiuce and it's totally ok from them so really doub where is the key point.

 

[AdiumY]

Whenever you taste burnt ejuice that always means too much power is/was used. I still say to completely break down the tank and give it a good wash. Let it dry. Smell it to see if odor is still there. If it is then soak the whole tank(minus to coil) in vodka or alcohol for a few hours. And change out the orings. Burnt taste gets into them and its hard to get it out. Once the tank get that burnt taste it will never go away if you do not completely clean that tank and change the o rings.
And put in a brand new coil, making sure it is totally saturated with juice by dripping some juice on the cotton until it looks like a slushy. The reduce the power on the mod and take a pull. New coil/atomizers need to be broken in slowly so after the first puffs or so up the watts by 2 ot 3. Do this until you find your sweet spot(where it tastes the best to you)

for the moment still dont understand where is the problem- burned juice, burned cutton or burned coil)) and firstly suppose need to clarify what is wrong)

 

[Sugar_and_Spice]

Hi, Yes i have wismerkrx200 and original TFV12( not prince) also. i tried to put prince on wismerk and it seems to me that the same problem.. juice i try several. SOme frined use jiuce and it's totally ok from them so really doub where is the key point.

Let me just say that the mods you are using(and any mod really) only supplies the power to the coil/tank. Only way that a mod causes any problems is when you have it set too high.

If you are using the ONE tank on all of the mods, the problem IS the tank. Not the mod. See my last post.

 

[Sugar_and_Spice]

for the moment still dont understand where is the problem- burned juice, burned cutton or burned coil)) and firstly suppose need to clarify what is wrong)

I just told you in my last 2 posts what is wrong. The burnt taste has gotten into the tank and to get ithe taste out, you have got to clean the tank.

Offering you a solution that you don't want to take?

 

[AdiumY]

Let me just say that the mods you are using(and any mod really) only supplies the power to the coil/tank. Only way that a mod causes any problems is when you have it set too high.

If you are using the ONE tank on all of the mods, the problem IS the tank. Not the mod. See my last post.

I just have and idea that mode is broken and supplying another wattage instead of that showned on the screen) i sett 60 and maybe mod supply 120) i just wanted to analyze this issue)

 

[AdiumY]

I just told you in my last 2 posts what is wrong. The burnt taste has gotten into the tank and to get ithe taste out, you have got to clean the tank.

Offering you a solution that you don't want to take?

Yes, im going to fix it as soon as get home) this is long process can't get done during day))
But at the same time i dont feel burn taste whet just start. it appears at least after half day with totally new coil and that's making me confused.

 

[Sugar_and_Spice]

I just have and idea that mode is broken and supplying another wattage instead of that showned on the screen) i sett 60 and maybe mod supply 120) i just wanted to analyze this issue)

You said that it happens on all of your mods. Or did I mis-read your post?

The only common denominator is the tank. All of those mods you listed cannot be bad and doing the exact same thing. Does any of your mods have a setting for soft, normal, hard? This refers to the type of hit you want.

 

[Sugar_and_Spice]

You said that it happens on all of your mods. Or did I mis-read your post?

The only common denominator is the tank. All of those mods you listed cannot be bad and doing the exact same thing. Does any of your mods have a setting for soft, normal, hard? This refers to the type of hit you want.

Also can you post pics of the coil and the mod? It may just be something simple. Or you may be asking the mod and coil to do something that neither are capable of achieving.

 

[AdiumY]

You said that it happens on all of your mods. Or did I mis-read your post?

The only common denominator is the tank. All of those mods you listed cannot be bad and doing the exact same thing. Does any of your mods have a setting for soft, normal, hard? This refers to the type of hit you want.

Does any of your mods have a setting for soft, normal, hard?
You mean preheat mode? x priv has and i use low setting of preheat.

 

[Sugar_and_Spice]

Yes, im going to fix it as soon as get home) this is long process can't get done during day))
But at the same time i dont feel burn taste whet just start. it appears at least after half day with totally new coil and that's making me confused.

Are you chain vaping? Are you allowing the ejuice time to replenish the coil before taking that next hit. Higher vg ejuice takes longer to replenish the wick due to its thickness.

I would also suggest having more than one set up in your daily rotation, especially if you chain vape. Switching between two or more mods on a routine schedule can help with that. Get another tank whether it is the same as you already have or a different one and fill each with different ejuice. That helps to save your battery life and coil life by giving it some time to rest between vaping.

 

[Sugar_and_Spice]

Does any of your mods have a setting for soft, normal, hard?
You mean preheat mode? x priv has and i use low setting of preheat.

No not preheat. I have an x priv, let me go check it.

 

[AdiumY]

Are you chain vaping? Are you allowing the ejuice time to replenish the coil before taking that next hit. Higher vg ejuice takes longer to replenish the wick due to its thickness.

I would also suggest having more than one set up in your daily rotation, especially if you chain vape. Switching between two or more mods on a routine schedule can help with that. Get another tank whether it is the same as you already have or a different one and fill each with different ejuice. That helps to save your battery life and coil life by giving it some time to rest between vaping.

Not so agressive chain, maybe 2 puffs, then usually provide at least 10-15 ceconds.. maybe it's not enought?) taking 2 mods and 2 tanks with you for a day is not so comfortable) so prefer using only one)

 

[AdiumY]

No not preheat. I have an x priv, let me go check it.

Just tell please what pic of my mode can help you for better understanding?)

 

[AdiumY]

So here are settings i have and use this one juice

 

[AdiumY]

And try to make a hit no longer than 3 seconds

 

[Sugar_and_Spice]

I found these instructions. Just click on it to be shown how the settings work in the x-priv.

https://vapebeat.com/vape-user-guides/how-to-use-smok-mods-settings-menu-explained

 

[Sugar_and_Spice]

So here are settings i have and use this one juice

Look at your pic of the mod. See where it says soft? It is listed just under the wattage. This is what I was referring to. But you already have it set to soft. Can you take the mod back to where you bought it to have them look at it?