Smoketech 2.0 atyy problems

[GrimReaper]

hey guys i bought 4 of the smoke tech 2.0 ohm attys the other day they all got here today and they just refuse to work right. ive tried them in a 3.7 650 mah ego batt. i even tried them in a couple 5v passthoughs i have made. each time they will produce vapor, but its like non existant on the exhale. you know like when an atty is dieing and u can draw in some vapor and then you go to blow out theres just no vapor at all and a burnt ish taste? i blew out the primer then i added about 4 drops. i tried to vape on it a little to start it and it acted as above. being mid lr and reg i went ahead and added a couple more drops. still the very same thing on ALL 4. anyone got any ideas on whats going on? i didnt want to submit a ticket if its my fault. i dont even know what the result in submitting a ticket would be.

 

[six]

Do you have a multimeter? The first thing to do is check to make sure they are 2.0 ohms.

 

[GrimReaper]

Do you have a multimeter? The first thing to do is check to make sure they are 2.0 ohms.

i do just not on me right now but ill have it tomorrow, would it matter reguardless since i used it on a 3.7 4.2 and a 5.1 volt device and had the same results every voltage?

 

[six]

It might. -- If they were 4 ohms or above, they would behave about the same on 3.7 to 5 volts.

As to your method - After cleaning the primer out of them, I start those smoke tech attys out with about 6 drops. And, I've had a couple that needed just a little break in time before they really started cranking out vapor. -- If they gurgle at all when you take a pull, they are flooded. -- I don't have much else to say about them. They've been pretty good attys for me and I use the 2.0 ohm smoke techs often.