So.... I bought a Nemesis... any tips?

Status
Not open for further replies.

John_

Ultra Member
ECF Veteran
Verified Member
May 22, 2013
1,109
837
Riverside, California, USA
I just bought a Nemesis (Matte) and it should arrive in a couple days. I like mechs, and lets face it, the Nemesis looks amazing. The low voltage drop is good too. :) Any tips or advice about it that you think I should know? You know the kind of stuff you learn from actually having and using the device.
 

Dannyboy5691

Super Member
ECF Veteran
Verified Member
Apr 13, 2013
534
324
60
Hamburg, NY
Make sure you don't use the beauty ring unless you have the extended top pin. Otherwise the battery will rattle and not make contact. The firing switch will loosen up over a short time unless you snug it down with a pair of pliers. Just snug it a little and you shouldn't have any problems. Also, a guy on CV forums did a voltage drop test on the Nemmy. He found that with more metal/tubes=more drop. The Nemmy in 18350 had a .02 drop where the 18650 Nemmy had a .07 drop. It's a really good post in the Mech Mods section of the forum. Take a look at it as he's done quite a few mechs and batteries. Congrats on your Nemmy. :)
 
Status
Not open for further replies.

Users who are viewing this thread