So I don't learn the hard way ....

[anthonyjl]

My Kanger Mini pro tank 2 will be here today.
This is my first e-cig. How worried will I have to be about leaking fluids? I plan on carrying this around with me everywhere as I begin my analog free journey tomorrow morning so its important that I have it with me at all times.

 

[Sugar_and_Spice]

Hello,
Mine has not leaked a drop. what kind of battery are you using?

 

[anthonyjl]

Its a KGO. From what I have been reading I need to separate the two while not in use to extend the battery life. I bought minimum parts to begin with because I am a noob lol. If this week goes as planned I will purchase more batteries and another tank.

 

[meanckz]

always have back ups....most Kanger are glass, glass can break....as long as you tighten everything and don't loose o-rings, you won't have leakage.

welcome to ECF too


exchange the coils when needed
DiscountVapers.com has authentic Kanger coils for less than $6 for 5 of them.

I love my Kangers

 

[WindyCityJoe]

Should be ok as long as you keep everything screwed together tight but don't overtighten. I like my mini PT2 but had to remove a flavor wick due to burnt hits.

 

[anthonyjl]

What if it gets tipped upside down?
I'll keep that in mind. I definitely want to get plenty of coils stocked up too.
Do you sell diy e juice supplies?

 

[meanckz]

also, check out this Katana Kit and this Kanger Mini Protank 2 Starter Kit -VV, I just received the latter very recently and a gratis 30ml bottle of juice.

 

[anthonyjl]

Should be ok as long as you keep everything screwed together tight but don't overtighten. I like my mini PT2 but had to remove a flavor wick due to burnt hits.

I've heard about that too. Especially with 100% VG. There are two flavor wicks right? Just remove one and I should be good?

 

[rawr]

My Kanger Mini pro tank 2 will be here today.
This is my first e-cig. How worried will I have to be about leaking fluids? I plan on carrying this around with me everywhere as I begin my analog free journey tomorrow morning so its important that I have it with me at all times.

I guess it will leak at some point.. It has evod/protank coil head, screwed in the base and you should not overtight it, cause it squeezes the o-ring too much. Also the cillindric cap has hole on the top and can leak through it if you turne the atomizer upside down ant the gasket inside is squashed.

Dont worry! Its gonna leak few micro drops at most. Once a week clean the battery pin with ear bud and maybe alcohol and you are good.

 

[anthonyjl]

My Kanger Mini pro tank 2 will be here today.
This is my first e-cig. How worried will I have to be about leaking fluids? I plan on carrying this around with me everywhere as I begin my analog free journey tomorrow morning so its important that I have it with me at all times.

I guess it will leak at some point.. It has evod/protank coil head, screwed in the base and you should not overtight it, cause it squeezes the o-ring too much. Also the cillindric cap has hole on the top and can leak through it if you turne the atomizer upside down ant the gasket inside is squashed.

Dont worry! Its gonna leak few micro drops at most. Once a week clean the battery pin with ear bud and maybe alcohol and you are good.

I can handle a little so long as my pocket isn't filled with e-juice lol

 

[WindyCityJoe]

Still shouldn't leak, you have to turn it upside down to fill it. As meankcz mentioned be careful of the glass, drop it once on a hard surface and it'll be time for a new tank!

 

[rawr]

Should be ok as long as you keep everything screwed together tight but don't overtighten. I like my mini PT2 but had to remove a flavor wick due to burnt hits.

Mine protank and mini had leaked after removing the top silica piece. I dont recommend doing that.

If it was burnt, then the voltage was too high for the resistance of the coil or you should try to use less VG juice. 100% VG and evod/protank coil head is no go.

 

[anthonyjl]

Still shouldn't leak, you have to turn it upside down to fill it. As meankcz mentioned be careful of the glass, drop it once on a hard surface and it'll be time for a new tank!

Ok. I would like to keep it around my neck but the work place won't allow that. I'll just have to be uber cautious

 

[WindyCityJoe]

I just remove 1 flavor wick, but others recommend removing both. It's kind of trial and error.

 

[Sugar_and_Spice]

What if it gets tipped upside down?
I'll keep that in mind. I definitely want to get plenty of coils stocked up too.
Do you sell diy e juice supplies?

Ok to turn upside down if ya wanted to.
DIY supplies can be gotten from loads of vendors.
mtbakervaper
freedomsmoke

 

[anthonyjl]

Should be ok as long as you keep everything screwed together tight but don't overtighten. I like my mini PT2 but had to remove a flavor wick due to burnt hits.

Mine protank and mini had leaked after removing the top silica piece. I dont recommend doing that.

If it was burnt, then the voltage was too high for the resistance of the coil or you should try to use less VG juice. 100% VG and evod/protank coil head is no go.

For some reason PG made me nervous. I was afraid it could be harmful to me so I went 100% VG. I may dilute with distilled water a little to help out.

 

[rawr]

Still shouldn't leak, you have to turn it upside down to fill it. As meankcz mentioned be careful of the glass, drop it once on a hard surface and it'll be time for a new tank!

That isnt necessarily true I dropped mine protank 1st gen 3 times at the hard wooden floor and its still in 1 piece.

 

[Sugar_and_Spice]

Still shouldn't leak, you have to turn it upside down to fill it. As meankcz mentioned be careful of the glass, drop it once on a hard surface and it'll be time for a new tank!

The protank ii has come out with replacement tanks and in colors too. Discount vapers. com
If the mini hasn't it should soon.
Glass can be better for some vapers who use ejuice like a citrus or cinnamon flavor. These types of ejuice eat plastic.

 

[rawr]

Ok. I would like to keep it around my neck but the work place won't allow that. I'll just have to be uber cautious

You worry too much Just keep it laying on the desk and its all good. Just be careful that the battery with attached atty dont roll of the desk lol

 

[WindyCityJoe]

Hey rawr, thanks for the feedback but tried adjusting wattage and voltage with no luck, since removing the flavor wick I've had no more burned hits or leaks. I also realize that not every drop will cause the glass to break, it is glass though and eventually your luck will run out.