I bought a kayfun lite and I loved the taste but the draw was too tight for me. I have drilled out several of my other airholes on tanks to fix this so I thought no biggie. I watched a couple of videos on others doing this just to make sure. Long story short the bit superheated and melted sealing off the air. I tried to use a cold forged bit and it just won't eat through it. It doesn't look reall pretty right now but I want it functional. Does anyone use special bits? I only have an 18v hand drill I used but I normally use my dremel and it worked fine on all the other tanks. Any help is appreciated or possibly some one with access to a drill press that would help with a few bucks through paypal on my end? I am located in Des Moines IA but would be willing to ship.
