some work and some don't

[edwardj]

I am having a problem that I don't understand. I have a mixture of Spinner 2, original Spinner, eGo Twist and a few old regular eGo batteries (must buy more!!). I use them on a combination of Kanger T3S, T3D and the Vision Spider. My problem is this, some of the batteries won't power some of the clearomizers. If I mix them up, they both fire. Does anyone know what might be causing this?

Asimovtrek

 

[Cullin Kin]

I think it might be that some of your tanks could may be too low in resistance for some of your batteries.

 

[imsoenthused]

Sounds like a dropped/compressed center pin to me. It happens when you screw some attachment on with a slightly longer 510 connection, it presses the positive pin down, then you try screwing something on with a slightly shorter connection and it just doesn't make contact. It's a side effect of these being cheap mass produced Chinese devices with fairly loose tolerances. Take a little screwdriver, tweezers, etc and lift that center post up some and see if it works then. Be gentle, you can break the connection and ruin the battery if you jerk and wiggle it around a lot.