HI all..new member here..I bought an Aegis Boost Plus..My ? is can I replace the coil, with juice in the pod, and not spill it everywhere?
spilling juice
- Thread starter scarylarry
- Start date
- th_trl_thread_readers 0
- Status
@scarylarry , I don't have a Boost but I did some looking around and found a review that instructs to empty the pod when changing the coil.
[2020 Newest] GeekVape Aegis Boost Plus Review: The Mighty Boost?
Only one way to find out for sure though, I guess.
[2020 Newest] GeekVape Aegis Boost Plus Review: The Mighty Boost?
Only one way to find out for sure though, I guess.
Welcome to ecf @scarylarry 
It looks like if you hold the pod upside down with a firm grip, the coil shoul slide right right out and be replaced with a new one. Might be a good idea to vape down as much juice as possible for less spillage if that should occur. Of course, wait 10-15 minutes for the juice to saturate the coil if you haven't already done so before inserting it to prevent dry hits.
It looks like if you hold the pod upside down with a firm grip, the coil shoul slide right right out and be replaced with a new one. Might be a good idea to vape down as much juice as possible for less spillage if that should occur. Of course, wait 10-15 minutes for the juice to saturate the coil if you haven't already done so before inserting it to prevent dry hits.
I don't have a Plus, but I have the Pro - they use very similar pods. If you hold the pod vent side up (refill side down), you can technically keep as much juice in there up to the point of where it isn't touching the coil.
Here I noted on both ends with arrows, the lowest point in which juice can come out of the tank. If you tilt it slightly to its side, both of those points will be even, holding as much juice as it can for the removal of the coil. If I had to guess, I'd say you can keep somewhere close to 2/3 of a full tank before you're going to run into a leaking issue during coil replacement since the displacement of the coil takes up much of the top half of the tank when holding it this way.
Also thanks for posting this, I forgot my Boost Pro even existed, and now I'm vaping on it again. XD
Welcome to ECF and cheers.
As with most pods, if you remove the coil while the pod has e-liquid in it, the pod will spill out the e-liquid.
What I find that works is to turn the pod upside down, drip tip facing downwards, place your finger tightly over the drip tip opening then remove the coil.
Keep your finger tightly over the opening in the drip tip while you replace the coil.
Once done, turn the pod the right way up and remove your finger. You should fine the e-liquid is still on the pod with very little spillage.
What I find that works is to turn the pod upside down, drip tip facing downwards, place your finger tightly over the drip tip opening then remove the coil.
Keep your finger tightly over the opening in the drip tip while you replace the coil.
Once done, turn the pod the right way up and remove your finger. You should fine the e-liquid is still on the pod with very little spillage.
- Status
Similar threads
- Locked
