Spinner-protank not liking each other

[nampla]

My protank/protank2 do not like my Vision Spinner.
The spinner blinks whenever I try to use 'em both. No workie... it's like there is a short.
Changed attys, still no luck.

Seems to work with my T2 and EVODs, just not w/ the tanks.

Stumped

Ideas, suggestions...?

 

[bluecat]

My protank/protank2 do not like my Vision Spinner.
The spinner blinks whenever I try to use 'em both. No workie... it's like there is a short.
Changed attys, still no luck.

Seems to work with my T2 and EVODs, just not w/ the tanks.

Stumped

Ideas, suggestions...?

Check the protank with a multimeter, ohmmeter or device with one built in. See what ohms it is running at. Either shorted or too low ohms to fire on a Spinner.

 

[Zooka]

I had the same issue when I got my latest vision spinner. Are you using the beauty ring? I've found that if I don't screw the beauty ring all the way down, leaving just a tiny little bit of a gap at the bottom, then tighten down the protank 2 onto it works perfect. Not really sure why this helps, but it might be the same thing happening to you.